Sixth Army Group  

Go Back   Sixth Army Group > Discussion Areas > Armor, Mech and Weapons Division

Armor, Mech and Weapons Division Showcase of 1:6 Armor, Vehicles and Weapons Projects

Reply
 
Thread Tools Display Modes
Old 11-28-2005, 10:01 PM   #1
Die Werkstatt
Company Commander
 
Join Date: Jun 2005
Location: Phoenix, AZ
Posts: 1,189


I may have to buy a second Puppchen...

My Puppchen came today and its great but I noticed that the carriage is the same as this...

The XT-7 Rotkappchen



One of the most advanced weapon conceived by the germans in WW II was the Panzerabwehrrakete X-7 ("tank defense rocket") anti-tank guided missile, nickname Rotkšppchen ("little red riding hood"), project number 8-347. Developments for a guided AT missile begun as early as 1941 when BMW (the car company) offered the weapon to the army's weapons bureau. Because of the then generally good military war situation the army wanted to save the projected development costs of 798,000 RM. In 1942 Dr.Kramer of the german research institute for aircraft developed rocket engines for weapons that resulted in the X-series of guided bombs and precision weaponry of which the X-7 was the smallest family member. The first prototype was followed by a larger production model with a changed detonator for the shaped charge of 2.5 kg. The back part of the main body (length 46.5 cm; diameter 15 cm)contained the two-stage solid fuel rocket engine 109-506 developed and made by the company WASAG. The wings were swept forward and had wingtips which housed the guidance wires, wingspan was 60cm. The small elevator/steering rudder assembly was set off 13.2 cm of the main body's axis. Total length including the protruding detonator cap (diameter: 3.8 cm) was 95cm. The fully loaded Rotkšppchen weighed 9kg. The missile was to be launched from a start rail tripod that was 150cm long and weighed 15kg. the missile's rocket engine was ignited with a 300V battery. This fired the 2g gunpowder positioned in the two hollow half rounds of the gyro stabilizer. the explosion gases exited through two tangential openings and immediately brought the gyro to operating speed. Then the 3kg of propellant of the first stage of the rocket engine were ignited. They developed 68kp thrust and accelerated the missile to it's flight speed of 98m/s in 2.5 sec. In flight the X-7 rotated around it's axis at a rate of two rotations/sec. Guidance commands from the gunner were transmitted over the two wires, one for longitudinal and one for lateral corrections. A delay mechanism let the steering rudder of the elevator only work when it was in the right position for the respective command, in other words, the elevator worked both as a (longitudinal) elevator and a (lateral) rudder. Guidance was achieved through optical tracking of the small tracer in the rear of the rocket that was to be kept superimposed over the target by the gunner's commands until it impacted (a method still in use today and known as CLOS for command-line-of-sight). The second stage of the rocket engine developed a thrust of 6kg for 8sec. This sufficed to keep up a speed of over 300km/h and reach a range of 1200m. The shaped charge warhead was strong enough for all known tanks of that era. A trial was undertaken on September 21st 1944 with seven X-7 missiles. Because of the unusual and unfamiliar flying characteristics the first four weapons had ground contact after some distance and therefore crashed. On the next two the rocket engine exploded on the way to the target. The last Rotkšppchen flew all the way and hit the target tank at a range of 500m dead center. Only about 300 X-7 Rotkšppchen were completed; mass production was planned and had already started at the companies Ruhrstahlwerke in Brackwede and the Mechanische Werke in Neubrandenburg. Many almost finished weapons were captured by the allies. It is unclear whether the combat trial at the front took place or which results it had. Improvements of the X-7 Rotkšppchen were the Steinbock which used infra-red transmitting of the guidance command and therefore didn't require the wires. An automated tracking device was the Pfeifenkopf or Pinsel project. It utilised a machine that computed the changes in angle of the two sighting devices - one was to be aimed at the target, the other at the missile- into commands for the missile. This mechanism was further atomated in the Zielsuchgeršt ("target aquisition device"). By using an image recognition device called Ikonoskop the missile was to seek its target through it's own optical sensor that compared the image data from the aiming device with the data it received from its own optical sensor. Besides these avionics and electronic equipment, other long range ATGMs were the Rochen-600, Rochen-1000 and Rochen-2000 for ranges of 500m , 1500m and 3000m respectively. Another project called Flunder utilized many parts of the Panzerfaust including it's warhead and using it's launch tube for the rocket engine. None of these projects were completed.
__________________
Rick Ivansek - Cave Creek, AZ
Die Werkstatt is offline   Reply With Quote
Old 11-28-2005, 10:44 PM   #2
Reizbar
Battalion Commander
 
Reizbar's Avatar
 
Join Date: Jun 2005
Posts: 1,695
Images: 1


Rick,

That is an awsome find! Any idea what the gunner's sight looked like? I just found this doing a search:

Panzerabwehrrakete
__________________
Tim

There is a fine line between "hobby" and "mental illness."
Reizbar is offline   Reply With Quote
Old 11-29-2005, 01:31 AM   #3
johnro6659
Brigade Commander
 
johnro6659's Avatar
 
Join Date: Jun 2005
Location: Third rock from the sun
Posts: 4,397
Images: 11
I'm with you I might have to get two Pups now.
__________________
John Romano
Fahrzeugwerke Deutschland
New England Area One-Sixth Scale
The Fighting Sixth of New England
Bella detesta matribus
johnro6659 is offline   Reply With Quote
Old 11-29-2005, 05:01 AM   #4
inxsone
Brigade Commander & Mod
 
inxsone's Avatar
 
Join Date: Jun 2005
Location: So.Cal. - U.S.A.
Posts: 3,491
Images: 8


VERY interesting and cool subject Rick... I'd like to see your take on it when you get around to playing with one of those Puppchen carriages... Also the fact that the actual DML Puppchen assembly completely lifts off the carriage would help you if you planned to make the rocket launcher interchangable... Two AT weapons for the price of one depending on what you feel like displaying...
__________________
I am 10-98... Mike
inxsone is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT. The time now is 10:47 PM.


vBulletin
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
©2005 - 2015 www.sixtharmygroup.com